Sunday, January 15, 2012

Temperature Remains High at Reactor 2 Pressure Vessel at #Fukushima I Nuke Plant

It went as high as 142 degrees Celsius on January 14 before it came down to 138 degrees Celsius on January 15 at "CRD Housing Upper Part" of the Reactor Pressure Vessel of Reactor 2 at Fukushima I Nuclear Power Plant.

Looking at the numbers, erratic movement started on January 12 when the temperature at the location jumped from 48.4 degrees Celsius at 5PM to 102.3 degrees Celsius at 11PM. TEPCO says it's just malfunctioning, but the temperature had been stable up to that point.

From TEPCO's latest (1/16/2012) plant parameters, "temperature of Reactor 2":


11 comments:

CaptD said...

This is what I call the Fuky Effect...
I believe it is caused by the interaction of the ground water, the remaining containment debris and the corium(s)...
+
It is quite possible that the radioactiv­e steam “event” that many have been warning about, has indeed started to happen and it is now just slowing “venting” radioactiv­ity into the atmosphere over Japan!

The wind charts for the last few days will tell the tale as will the future… http://www­.zerohedge­.com/artic­le/interac­tive-japan­-wind-map

kintaman said...

So it is above 100C. This is means there is steam coming out of there if they are still applying water. This is NOT cold shutdown.

Commodity brokers said...

The paragraph and analytic report really memorable.The blog is really nice one and full of information we appreciate the kind of information you have provided in this post. The information are useful for all of us and we would like to thank you from the bottom of our heart for this wonderful information.

Atomfritz said...

This temperature spikes are measured at the control rod drive housing upper part.

If there was a melt-through, the instrument has displayed the infrared heat of the corium flowing nearby.
And, supposed there was a melt-through, one could assume that there some thermically hot blobs of material have fallen through the hole in the vessel, landed nearby and heating the instrument until they get flowed away by the cooling water.

If this is the case, then we can conduce safely that the material is still way above 100 C.

(There is probably much hotter material that is normally not reached by the cooling water, see the hot steam measured in the suppression chamber gas around late November.)

Yosaku said...

For what it's worth, the most recent temperature reading at this gauge was -6.3C (as of 1/17 11:00 am). http://www.tepco.co.jp/en/nu/fukushima-np/f1/images/12011712_temp_data_2u-e.pdf

arevamirpal::laprimavera said...

Thanks for the update. Now it looks kaput.

Atomfritz said...

Maybe the results of the peephole inspection will reveal that corium flowed out of the RPV near this thermoelement.
If so, this this could suggest a plausible explanation for the extreme readings and its early failure (probably because of losing its hermetic tightness due to thermal and chemical stress, and thus moisture practically shorting the instrument).

I really look forward to the videos from the inside of unit 2.

Unknown said...

New technology has been implementing for manufacturing of devices like Temperature Recorders which measure heat.

Unknown said...

Excellent and decent post. I found this much informative, as to what I was exactly searching for. Thanks for such post and please keep it up. Pressurized Equipment || Non Pressurized Equipment || Storage Tanks

PipeFittings said...

Nice post! I have bookmarked your blog for the future references.
We are leading 904L Seamless Tubes manufacturers.

Unknown said...

Visit our Free PDF books

Post a Comment